::::APACK::::

Home | Contact | Site map | Korea

Home > Technology > Printer Heating Roller

Electronics Cooling

Printer Heating Roller

Solar Heat Collector

E-Coil Heating Type Heating Roller

Quick FPOT
Direct Heat Transfer to Heat Roller Surface through Insulation Layer
Optimized Insulation Layer for Rapid Heat Transfer
100% of Electricity is Convertible into Joule Heat

NON Inrush Current
Constant Electric Resistance on Temperature Level

LOW LEVEL Heater Temperature
Extreme Improvement of Heater Endurance (Max. Million Pages over)

High Heat Capacity
Lower Power Consumption than Other Fusers
Extremely Lower Level on FLICKER than Other Fusers
Guarantee Higher Fixity on Thick Paper than Other Fusers
Small Axial Temperature Variation
Easy Temperature Control

-Warm-Up Time & FPOT (Ø40, 1.3 kW, 35 ppm)

IH Heating Type Heat Roller

Principle of High-frequency Induction Heating: Refers to a rapid heating of derivatives located in the middle of coil that delivers high-frequency current due to over electric current by electron induction effect and heat loss in some of hystersis.

Item		IH Heating Roller
Specifications / Performance	Energy Efficiency	Over 90%
	Warm Up (Normal Temp.→180℃)	Color 25 sec / Mono 16 sec
	Ready FPOT (First Print Out Time)	Color 16 sec / Mono 8 sec
	Control	Under 3℃ of Temp. Ripple / under Flicker 0.3
Applied Technology	Heating Method	Hybrid (Induction Heating + Joule Heating)
	Heat Roll	Ferro-Magnetic Thin Steel Sleeve (t0.5)
	Coil Winding	Declination Cu Ribbon Coil (2.0x0.1mm)
	Inverter Board	Secondary source of electricity from High Frequency Transformer
Effect	APACK’s genuine Instant Fuser technology IP Achieves High End Fuser Solution On-Shelf Enhances product competitiveness through reduced standby time for print out Low power consumption through reduced pre-heating power during standby

Company | Technology | Product | Support